Skip to content
Knowledge base

How do I give tools and machining principles a logical name in CAM iX?

Build tool and machining principle names from fixed abbreviations for operation, diameter, depth, machine and priority, and record them in one list.

Short answer: build every name from fixed abbreviations separated by underscores: type of operation, diameter, depth range and, where needed, machine, priority and formatting class. For example FRE_Ø16_00→42_Vlakfrees for a tool and BOR_VERT_Ø05_00→35_P10 for a machining principle. Record the abbreviations in a list and in the folder structure, so everyone can read the names.

Information

Applies to

  • imos iX 2017 and later with CAM iX
  • Module: imos CAM iX (tool types, tools, machining principles)
  • Integrations: the postprocessor for your CNC machine, for example Homag or Biesse
  • Last reviewed: October 2026

Step 1: naming tools

  1. Ask the operator for each tool's name in the machine (for example FRESAD16), direction of rotation, usable length and diameter.
  2. Create a folder per machine if the tooling differs between machines, with a subfolder per tool type.
  3. Open an existing standard tool, enter a new name and save.
  4. Build the name: FRE (milling), Ø16 (diameter), 00→42 (minimum and maximum machining depth) and a description the workshop recognises: FRE_Ø16_00→42_Vlakfrees.
  5. Link the machine's tool type with the red browse button. The parameters are then prepared for you.
  6. Fill in the data and save the tool in the right folder.
Tip

Type Ø with ALT+157 and → with ALT+26; each saves two characters. Write 00 instead of 0 and Ø05 instead of Ø5, so the names sort neatly below each other.

Step 2: naming machining principles

Principles follow the same structure, extended with machine, priority and class. The full set of abbreviations is in machining principles and formatting classes.

  1. If you run several machines, start with a machine prefix, for example X_ for one machine and B_ for the other.
  2. Put the priority in the name: P10, P20.
  3. For material-dependent principles, add the formatting class, for example K1.
  4. Create a folder per abbreviation with a folder name that explains it, for example BOR Boren (drilling) with VER Verticaal below it.
  5. Keep an abbreviation list and update it with every change.

Why this approach?

Names are limited in length and the log file only shows the name. With a fixed structure you see at once which tool, depth and priority were chosen, and you quickly find the right variant when something changes on the machine.

Frequently asked questions

Does the imos name have to match the tool name in the machine?

No. The imos name is for readability; you enter the machine's tool name or number in the tool data. If your machine can select by name or diameter, use that: the spindle position then no longer matters.

Do I need to rename a tool after it has been resharpened?

Usually not. We set up imos with machine compensation wherever possible, so a resharpened tool does not immediately need a new diameter in imos. Keep the name at the nominal size.

Further reading

More than one solution

Almost every question in this knowledge base has more than one solution. The best fit depends on your workflow, machinery and integrations. Not sure which applies to you, or are you using software we don't (yet) support? Feel free to email Wood Intelligence. We're happy to think along with any challenge.

imos is a trademark of imos AG. Wood Intelligence is an independent consultancy.

Download access

Sign in to check whether this download is available.