Skip to content
Knowledge base

Edging before, on or after CNC: which order in imos iX?

imos iX has three machining orders for edge banding: before, on or after the CNC. The choice decides whether you can mill angles and curves.

Short answer: in the imos iX panel definition you choose a machining order per edge. Edging before CNC is the default for straight panels. Use edging after CNC when the CNC must mill the outer contour first, as with angles and curves. Edging on CNC is only for a machine that can apply edge banding itself.

In Wood Intelligence implementations we often see an angled or curved panel come out of the machine wrong because the machining order is still on the default.

Information

Applies to

  • imos iX CAD and CAM iX
  • Functions: panel definitions, edge settings per panel edge
  • Integrations: cutting list, edgebander and CNC (nesting or machining centre)
  • Last reviewed: November 2026

The three orders side by side

Machining orderWhat happensWhen to use
Edging before CNCThe edge banding is applied before the panel goes onto the CNC.Straight panels that go straight to the edgebander after sawing.
Edging after CNCThe edge banding is applied after the CNC has machined the edge, usually by milling.Angles, curves and other free contours that the CNC formats.
Edging on CNCThe CNC applies the edge banding itself during the program.Only with a machine that has an edging unit, such as a Homag BAZ that rounds and edges in one go.

Setting the order

  1. Open the panel definition of the panel.
  2. Select the edge you want to change.
  3. Choose the machining order: before, on or after CNC.
  4. Save the panel definition and refresh the cabinet.
  5. Check the cutting size and the CNC program of a test panel.
Tip

Use the filter function in the order to select all edges with the same situation, for example an angled edge, at once. You then set the order for all of them together.

Why this approach?

The order decides who makes the shape. With edging before CNC the panel is already sized and edged; the CNC only drills and mills inside the panel. If the CNC has to mill the outer contour, it would mill the edge banding off again. That is why angles and curves use edging after CNC: format first, then edge.

The choice affects the oversize. A panel that still gets edge banding after the CNC is sized differently from a panel that arrives already edged. If the order is wrong, the size of the finished part no longer matches.

Frequently asked questions

What is the difference between edging before CNC and edging after CNC?

With edging before CNC the band is applied before the panel goes onto the CNC. With edging after CNC the CNC mills the edge first and the band is applied afterwards.

Which order do I choose for a curved or angled panel?

Edging after CNC. The CNC formats the outer contour first, then the panel goes to the edgebander.

When do I use edging on CNC?

Only if your CNC can apply edge banding itself during the program, for example a machine with an edging unit such as a Homag BAZ.

Further reading

More than one solution

Almost every question in this knowledge base has more than one solution. The best fit depends on your workflow, machinery and integrations. Not sure which applies to you, or are you using software we don't (yet) support? Feel free to email Wood Intelligence. We're happy to think along with any challenge.

imos is a trademark of imos AG. Homag is a trademark of HOMAG Group AG. Wood Intelligence is an independent consultancy.

Download access

Sign in to check whether this download is available.